Hydrotreating and Isomerization Unit

1.jpg

Project, supply of equipment and construction of gasoline hydrotreating and isomerization unit are fulfilled by corporation JGC Corporation (Japan) on technology of UOP firm (USA).

General designer of the enterprise – is JSC "Nizhegorodniinefteproekt."

2006 - commissioning of the Unit.

Gasoline hydrotreating and isomerization unit includes:

  • section of hydrotreating and stabilization of gasolines from atmospheric distillation unit and delayed coker unit;

  • section of division of wide petrol fraction for a purpose of allocation of BP-85 C fraction

  • section of isomerization of BP-85 C fraction.

Section of gasolines hydrotreating and stabilization is intended for purification of gasolines from sulfur, nitrogen - and oxygencontaining hydrocarbons on the special catalyst in the presence of hydrogen, and also stabilization of gasolines from section of diesel fuel hydrotreating and dewaxing unit by a rectification method.

Design capacity of the section of gasolines hydrotreating and stabilization on raw material in continuous work 330 days/year is:

  • on the node of hydrotreating - 470 000 tons / year (60 tons / h);

  • on the node of stabilization - 554 000 tons / year (70 tons / h).

Production: hydrotreated gasoline, liquefied gas.

Section of division of wide gasoline fraction is intended to increase the octane number of wide gasoline fraction by distillation of low-octane components C5 - C6 from its composition.

Design capacity of the section on raw material, including gasoline from existing hydrotreating unit is - 870 000 t / year (110 t / h).

Production: fraction BP-85 C (raw material of  isomerization), fraction BP 85-180 C (raw material of reforming).

Isomerization section of fraction BP-85 C is used to increase the octane number by its isomerization on the special catalyst in the presence of hydrogen.

Design capacity of the section of isomerization on raw material is:

173 300 tons/year (22 t/h). Production: isomerizate (high octane component).

Characteristic of finished product:Mass fraction of sulfur, ppm no more – 0,5

Concentration of actual resins, mg / 100 cm3 of petrol , no more- 5,0

Volume fraction of benzene,%, no more - 3

Appearance – pure, transparent.